Installing The Blind Spot Aid; Connecting The Blind Spot Assistant - Dometic MWE 4104 Instructions De Montage Et De Service

MWE4104
7

Installing the blind spot aid

See fig. 6 to fig. 0
Supplementary to fig. b
A
NOTICE! Risk of malfunction!
Align the sensor holders so that the fastening lugs are horizontal.
The detection range of the sensors is larger horizontally than it is verti-
cally. If the sensors are not level, the ground may be detected.
➤ Push the sensor holders into the holes until they lock into place.
8

Connecting the blind spot assistant

See fig. a
No. Description
1 Control electronics
2 Yellow/black cable: Connection to the cruise control
(4 pulses every 1 m, square wave, amplitude 5 – 32 V)
If no speed signal is available the system can be activated by the
indicators only.
3 Red/gray cable: Activating a video system.
Connect the red/grey cable to the activation trigger (rear) of the
video system.
4 White/blue cable: Connection to parking brake (see below)
switches the system off as soon as a ground signal is present
If not connected to the parking brake the wire must be connected
to ignition power.
5 Connection to LED display:
Black cable
White cable
Red cable
6 Connection to external loudspeaker (accessory)
Yellow cable
Blue cable
7 Blue/black cable: Connection to ignition
EN
Installing the blind spot aid
Plug socket
for plug
–
14
13
12
3
4
10
9
2
8
7