Detection Range - Dometic MWE 4104 Instructions De Montage Et De Service

Detection range

No. Description
8 Yellow/blue cable: Connection to turn indicator.
Activates the signal of the red/gray cable (trigger signal to e.g.
activate a video system).
If not connected to the turn indicator it must be connected to
12 V/24 V!
9 Switch connection:
Black cable
White cable
Red cable not connected
10 Sensors
11 Brown cable: Connection to ground
I
NOTE
The manufacturer recommends applying some grease to the sensor
plug connections (not on the control module).
9 Detection range
See fig. b
The detection range of the blind spot assistant is divided into two zones:
• Zone 1
Nearly all objects in this zone are displayed.
The orange LEDs light up in the LED display.
Every two seconds, a beep sounds.
• Stop zone (2)
If there are objects in this zone, the blind spot assistant emits a beep once a sec-
ond, warning you to stop.
The red LEDs light up in the LED display.
Virtually all objects are displayed in this zone, but some objects may end up in
the blind spot of the sensors.
8
MWE4104
Plug socket
for plug
7
5
6
–
–
1
EN