Using The Pc-3000 Signal Interface Switcher - Sony VPHG90E Mode D'emploi

Connection Examples

Using the PC-3000 Signal Interface Switcher

TRIGGER
5BNC cable
46
(GB) Installation/connection examples
When you connect the PC-3000 Signal Interfrace Switcher (not supplied)
to the INPUT A section, you can connect easily various input sources and
switch them by pressing the SWITCHER/VIDEO MEMORY/INDEX keys
on the remote commander.
*
IN OUT
R
IN OUT Y IN C IN
R-Y/P
IN OUT
VIDEO S VIDEO
VIDEO
LINK
IN OUT
RS-232C/422A
RS-232C RS-422A
PLUG IN POWER
CONTROL S DEVICE INDEX
INPUT A
to OUTPUT
Computer PC-3000 Switcher
Note
Be sure to terminate the PJ COM IN or OUT connector not in use by
attaching the supplied terminator.
Setting up
• Set the device index number of the projector to "01"
• Set the switcher number to "1"on the switcher.
For setting, refer to the Operating Instructions of the switcher.
• When using the remote commander as a wireless remote control, activate
the remote control detector of a piece of the equipment in the system only
and deactivate those of the other equipment. Perform the setting on the
projector using "SIRCS RECEIVER" in the SET SETTING 2 menu
.
37 )
(GB)
For setting on the switcher, refer to the Operating Instructions of the switcher.
Rear
AC IN
G B SYNC/HD VD
Y B-Y/P
R B
INPUT A
IN PJ COM OUT
REMOTE
PJ COM IN
Attach the
supplied
terminator.
to PJ COM OUT
AC power cord (supplied)
to a wall outlet
PJ COM OUT
* For the VPH-G90E model :
IFB-G90E Video Interface Board
(optional)
Signal flow
(page 49
(GB)
).
(page