Battery Installation - Sony VPHG90E Mode D'emploi

Battery installation

1
Push to open the lid.
2
Install the three R6 (size AA) batteries (supplied)
with the correct polarity.
Be sure to install
the battery from
the ' side.
3
Replace the lid.
Notes on batteries
• Be careful that the battery orientation is correct when
inserting batteries.
• Do not mix old battery with new one, or different
types of batteries.
• If you do not intend to use the remote commander for
a long time, remove the batteries to avoid damage
from battery leakage. If a battery has leaked, remove
the batteries, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on wireless remote control operation
• Be sure that there is nothing to obstruct the infrared
beam between the remote commander and the
projector.
• The operation range is limited. The shorter the
distance between the remote commander and the
projector, the wider the angle within which the
remote commander can control the projector.
• The remote control detectors on the projector do not
operate when the remote commander is being used as
a wired remote control. If you wish to use the remote
commander as a wireless remote control, be sure to
remove the connecting cable from both the remote
commander and the projector.
Connecting the remote commander to the
projector
Rear of the projector
IN OUT
PLUG IN POWER
CONTROL S
CONTROL S IN
Remote control cable (supplied)
CONTROL
S OUT
17
Overview (GB)