Rear - Sony VPHG90E Mode D'emploi

Location and Function of Controls

Rear

5
STANDBY
6
7
!¡
TRIGGER
1 Signal interface board attachment part (INPUT
B)
An optional signal interface board such as IFB-12/12A
and IFB-40 can be attached to this section.
When the IFB-12/12A is attached, the signal input to
the INPUT A connectors can be output from the IFB-
12/12A by setting it to output mode.
2 MAIN POWER switch
3 AC IN socket
Connect the supplied AC power cord.
4 Signal interface board attachment part (INPUT
C)
An optional signal interface board can be attached to
this section.
Notes
• The IFB-40 cannot be attached to INPUT C.
• When the IFB-12/12A is attached, the IFB-12/12A
cannot be set to output mode.
12
(GB) Overview
R ON
!º 9
IN OUT
IN OUT
IN OUT
VIDEO S VIDEO
LINK VIDEO
IN OUT
PLUG IN POWER
CONTROL S DEVICE INDEX
!™ !£ !¢
R G B SYNC/HD
Y IN C IN
R-Y/P Y B-Y/P
R B
INPUT A
RS-232C/422A IN PJ COM
RS-232C RS-422A
REMOTE
!∞ !§ !¶
5 ON indicator
When the projector is turned on, this indicator lights in
green.
6 u STANDBY indicator
When the MAIN POWER switch on the projector is
turned ON, this indicator lights in orange, indicating
that the projector can be turned on/off using the remote
commander.
7 Rear remote control detector
8 INPUT A connectors (BNC type)
R/R-Y/P , G/Y, B/B-Y/P
R
connectors: Connect to the outputs of a computer or a
video camera. According to the connected
equipment, the RGB (R, G, B), component (R-Y,
Y, B-Y) or HDTV (P
1
2
3
4
8
VD
OUT
, SYNC/HD, VD
B
, Y, P ) signal is selected.
R B