Sony VPHG90E Mode D'emploi page 19

..........................................................................................................................................................................................................
1) For the VPH-G90E model, the optional IFB-G90E Video Interface Board is required for using the VIDEO connectors.
2
Press the ON key on the remote commander or the control panel.
The ON indicator on the rear of the projector lights in green.
A white screen with the message shown below (warming up screen)
appears on the screen. For getting a stable picture, make sure to allow
the projector to warm up for 20 minutes after turning it on.
The message disappears temporarily in about 35 seconds, and will
appear subsequently for 5 seconds every 30 seconds.
F o r o p t i m u m
p e r f o r m a n c e ,
w h i t e s c r e e n w i l l
r e m a i n f o r
2 0 m i n
F o r i m m e d i a t e u s e
p u s h [ M E N U ] k e y .
Press the MENU key to cancel the warming up screen and see the
picture immediately after the projector is turned on if, for example, the
adjustment has been finished and warming up is not needed.
3
Turn on the power of the connected equipment.
4
Select the input signal to be projected with the INPUT SELECT keys.
VIDEO and SELECT: To project the signal input from the
equipment connected to the VIDEO IN or S VIDEO IN (or Y IN/C IN)
1)
connectors. Press the VIDEO key, then select VIDEO or S VIDEO
by pressing the SELECT key.
A: To project the RGB, component or HDTV signal input from the
equipment connected to the INPUT A connectors.
B: To project the signal input from the equipment connected to the
optional interface board other than the IFB-40 installed to the
INPUT B section.
C: To project the signal input from the equipment connected to the
optional interface board installed to the INPUT C section.
When the PC-3000 or PC-1271/1271M Signal Interface Switcher is
connected: Set the SWITCHER/VIDEO MEMORY/INDEX select
switch to SWITCHER and then select the input with the number
keys 1 to 8.
Note
When you select the input signal connected to the INPUT A, INPUT B or
INPUT C section, be sure to select the correct signal in the SET SETTING
1 menu. If an incorrect signal is selected, picture may be distorted.
For details, see "The SET SETTING 1 Menu" on page 35 .
(GB)
19
Projecting (GB)