Ayce PC650ID Manuel D'utilisation page 43

Recycle unwanted materials instead of disposing of them. All
appliances and packaging should be sorted and tendered at a
regional recycling centre into to be processed in an ecological
manner.
Proven safety of the federal inspectorate for heavy current
installations ESTI.
2. Product symbols
In this manual and/or on the machine the following symbols are used. These
represent important information about the product or instructions on its use.
650 W
Rated output
650 W
220 - 240 V ~ 50 Hz
Rated voltage
220 - 240 V ~
50Hz
0 - 3000 /min no load
min
-1
speed
0 - 3000
13 mm max. collet
diamater
Ø 13 mm
180605_ayce_PC650ID_IM
10 mm drill capacity
in metal
Ø 10 mm
13 mm drill capacity
in concrete
Ø 13 mm
28 mm drill capacity
in wood
Ø 28 mm
3 m cable with Swiss
plug
3 M
OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
Inserting and removing a bit (Fig. 1)
Always ensure that the plug is disconnected from the power
!
source, the tool is switched off before inserting or removing
bits to prevent accidental starting.
WARNING
Fig. 1
Auxiliary handle and depth gauge (Fig. 2)
Always ensure that the drill is switched off and plug is re-
!
moved from the power point before making any adjustments.
WARNING
84 85
Your tool is fitted with a keyless chuck for
greater convenience, a chuck key is not
needed to secure a bit in the chuck.
The chuck also has a locking device to pre-
vent bits loosening in use.
1. To insert / remove a drill bit, hold the
collar with one hand; use your other
hand to rotate the sleeve of the chuck in
an anti-clockwise direction.
2. Open the chuck jaws sufficiently so as to
fit the desired bit.
3. Insert the drill bit into the chuck and
tighten securely by holding the collar
and rotating the sleeve in the clockwise
direction until you hear a "click".
180605_ayce_PC650ID_IM
|
GB