Ayce PC650ID Manuel D'utilisation page 46

6. Always clamp sheet metal. Support thin metal with a block of wood to avoid
distorting it.
NOTE: When operating the product at low speed for a longer period the motor may
overheat. Therefore take breaks of approx. 15 minutes on a regular basis to let the
motor cool down.
e. Drilling into masonry
1. For maximum performance, use carbide-tipped masonry drill bits when
drilling holes in brick, tile, concrete etc.
2. Use the drilling setting initially then revert to the hammer action once the hole
is established.
3. Apply light pressure and medium speed for best results in brick.
4. Apply additional pressure and high speed for hard materials such as concrete.
5. When drilling holes in tile, practice on a scrap piece to determine the best
speed and pressure.
NOTE: Reverse rotation during impact drilling may damage the drill and drill bit.
MAINTENANCE
Caution!Always disconnect the device before performing any adjustment or
maintenance operation. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
Disposal
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
180605_ayce_PC650ID_IM
90 91 |
GB
180605_ayce_PC650ID_IM