Ayce PC650ID Manuel D'utilisation page 44

Fig. 2
Never operate the product without the auxiliary handle to avoid
!
accidents and injury! Always ensure that the auxiliary handle is
attached and secured correctly before operation! The auxiliary
handle provides better control of the product should the tool
suddenly jam during use!
WARNING
180605_ayce_PC650ID_IM
1. Turn the handle grip anti-clockwise to
loosen the collar and slip it over the
chuck onto the tool.
2. Adjust the position of the handle to suit
the application, locate the keyway on the
collar of the drill into the appropriate
slot in the clamp, add the depth gauge
if required and tighten the handle to
secure it in place.
3. The auxiliary handle can be swivelled
360° to find the position that offers most
comfort and the easiest operation. The
depth gauge helps keep an accurate
depth when drilling holes to a set depth.
4. To change the position of the handle,
loosen the clamp by turning the handle,
partially remove the handle to free the
keyway from the slot, reposition the
handle and then retighten it.
5. To change the position of the depth
gauge, turn the grip of the handle anti-
clockwise until the depth gauge is loose
enough to slide in the hole. Set the depth,
checking the depth with a steel ruler for
the most accurate measurement and
then turn the handle grip clockwise to
tighten both the depth gauge and the
auxiliary handle in the required position.
Variable speed trigger switch (Fig. 3)
Fig. 3
Forward/reverse control (Fig. 4)
Change the rotational direction from forward to reverse by pressing the forward /
reverse control.
Only change the rotational direction when the product is switched
!
off and has come to a complete stop! Always ensure that the
forward / reverse rotation control is adjusted to the correct
position depending on the intended operation! Always push the
forward / reverse rotation control as far as it will go! Do not use
WARNING
the product with the control switch in an intermediate position!
Fig. 4
86 87
1. This tool has a variable speed switch that
delivers higher speed and torque with
increased trigger pressure. Speed is
controlled by the amount of switch trigger
depression.
2. If you press the lock on button while the
trigger switch is depressed, the switch
is kept in the operating position. This is
convenient when continuous operating
for extended periods of time is required.
3. To release the lock on button, press and
release the trigger switch.
1. To select forward rotation, release the
trigger switch and push the forward/
reverse control to the left side (as seen
from the operator's position) of the tool.
2. To select reverse, push the forward/
reverse control to the right side (as seen
from the operator's position) of the tool.
180605_ayce_PC650ID_IM
|
GB