Remaining Hazards; Technical Data - Scheppach DP16VL Traduction Des Instructions D'origine

Store the tools in a safe location
• Store unused devices in a dry, locked location that
is out of the reach of children.
Avoid overloading the device
• Operate the device only within the specified output
range. Do not use any low-powered machines for
heavy duty work. Do not use tools to perform work
for which they were not intended.
Maintain a steady foothold
• Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and
always keep your balance.
Pull out the mains plug
• Pull out the mains plug when not using the tool,
prior to maintenance, and when changing the drill
bit.
• Ensure that the mains connection is protected by
at least a 10 A-rated fuse.
Avoid unintentional start-up
• Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
• Always keep an eye on your machine and the
object you are working on. Never use the machine
when you are not concentrating or are distracted.
Never use the machine when you are under the
influence of alcohol or are taking medication.
Maximum workpiece size
• Workpieces (max. 20 x 20 cm) may only be pro-
cessed if they can be clamped securely on the drill
table or in the vise.
Check the tool for damage
Before using the tool, safety devices and any slightly
damaged parts must be carefully checked to ensure
that they are in good working order. Visually ex-
amine the tool's power cable on a regular basis.
All parts must be correctly assembled and meet all
the conditions required to ensure proper operation.
Unless otherwise specified in the operating instruc-
tions, any damaged safety devices and parts must
be properly repaired or replaced by a professionally
recognized workshop. Never use tools with defective
On/Off switches.
Warning! Using any plug-in tools and accesso-
ries other than those specified in these operat-
ing instructions can lead to injury.
Now, please read and follow all steps and proce-
dures included in the operating instructions.
26 І 64

REMAINING HAZARDS

The machine has been built using modern tech-
nology in accordance with recognized safety
rules. Some remaining hazards, however, may
still exist.
• Long hair and loose clothing can be hazardous
when the work piece is rotating. Wear personal
protective gear such as a hair net and tight fitting
work cothes.
• Wood chips and saw dust can be health hazard.
Be sure to wear personal protective gear such as
safety goggles and a dust mask. Use a vacuum
exhaust system.
• Thrown work pieces can lead to injury if the work
piece is not properly secured or fed, such as work-
ing without a limit stop.
• The use of incorrect or damaged mains cables
can lead to injuries caused by electricity.
• Damage to hearing if no suitable ear protection is
used.
Even when all safety measures are taken, some
remaining hazards which are not yet evident may
still be present.
Remaining hazards can be minimised by following
the instructions in „safety precautions", „proper use"
and in the entire operating manual.
In these operating instructions we have marked
the places that have to do with your safety with
this sign: m
6.

Technical data

Length x width x height mm
Tablesize mm
Tilting range table °
Rotation range table °
Distance chuck to table mm
Distance chuck to base plate
mm
ø spindle mm
Drilling chuck seat
Drilling chuck clamping range
mm
Drilling depth max. mm
Speeds /min
Speed motor /min
Motor
Motor power W
Operating mode
Weight kg
Subject to technical modifications!
445 x 225 x 590
162 x 158
- 45 / 0 / 45
360
max. 175
260
46
B16
1,5 - 16
50
600 - 950 - 1220
- 1650 - 2500
1490
230V~ / 50Hz
500
S2 15min
15,5