Ironing Function; After Using The Steam Brush - SilverCrest SDRB 1000 A1 Mode D'emploi

Ironing function

• Dismantle the brush attachment w from the
appliance (see "Attaching/detaching the brush
attachment").
• Connect the appliance to a correctly installed
and earthed mains power socket.
• Adjust the temperature regulator 3 as per the
international point symbols (Care Label) or the
type of material. The heating-up control lamp 5
glows. As soon as the set temperature has been re-
ached, the heating-up control lamp 5 goes out .
Washing label Type of
material
Chemical fibres,
e.g. viscose,
polyester
Silk, Wool
Cotton, Linen
Note:
If doubt exists, start with a low temperature and
gradually increase it to a higher one. With sensitive
materials we recommend carrying out an ironing
test at a concealed part (inside seam).
• For heavily creased laundry, you can use the steam
function by pressing the steam blast button 8. To
generate the steam, the temperature regula-tor 3
must be set to at least ••• or higher.
• Should the heating-up control lamp 5 glow during
the process, release the steam blast button 8
and wait for a few moments until the heating-up
control lamp 5 extinguishes.
• You can repeatedly press the steam blast button 8
Should you press the steam blast button 8 whilst
the heating-up control lamp 5 is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron 0.
Temperature
regulator 3 Should the water tank 1 become empty while the
•
appliance is in use, remove the plug 7 from the
(low
power socket before refilling it.
temperature)
••
• If you want to put the appliance down during
(medium
temperature)
•••
(high
temperature)

After using the steam brush

• Place the temperature regulator 3 at the position
• After use, ALWAYS remove the plug 7 from the
• Pour away any water remaining in the water
- 9 -
until the heating-up control lamp 5 glows or
water drips from the sole of the iron 0. Then,
wait until the heating-up control lamp 5 extin-
guishes before activating a further blast of
steam.
Note:
use, fold out the stands 9 to the front and place
the appliance on them. When you are ready to reu-
se the appliance, simply fold the stands 9 back
to the rear.
"MIN".
power socket.
tank 1 to do this, open, the water fill opening 2
of the water tank 1, turn the appliance upside
down and lightly swivel it.