Preparation For Use - Renfert tropic XL Mode D'emploi

At an angle of 115° there is a lid locking position, which will
hold the lid open in a stable position.
Caution:
If this position is overstretched, the hinges
could become damaged.
EN
3. Labelling foil
The non-permanent marker pen provided (7)
can be used to write on the labelling foil (4).
The foil can be removed from the lid in order to
exchange or inscribe the label.
Use the non-reflective side of the foil to write
on.
When replacing the foil, clip behind the 4 mount-
ing points which can be found on the lid.
Firstly, bend the retaining flaps towards the matt
surface (a).

4. Preparation for use

• After unpacking, quickly blow with compressed air.
• Lay the palette into the case base.
• Fill exclusively distilled water into the holes at the side of the base. Tap water will
have a detrimental effect on the function and will lead to calcification of the capillaries.
• The maximum fill level is approx. 4 mm below the upper edge of the porcelain mixing
palette.
• As soon as you notice an even distribution of moisture on the surface of the mixing pal-
ette, it is ready for use. On initial use it will take approx. 1 hour for complete saturation
with water.
EN
a
- 2 -
115°
7
Fig. 3
4
Fig. 4