Renkforce 754389 Notice D'emploi page 42

2. Operating mode „Multi-User"
Important:
The code lengths of master and user code can be different (e.g. 8-digit master
code and 5-digit user code). 4-8 digit codes are possible.
If, however, the function „Auto-Entry" (see chapter 10. g) has been activated, the
code length of master code and user codes must be the same (e.g. 5 digits).
Observe:
When selecting the user codes and the codes for the access lock, it is important
that no code is used that differs in the first digit by changing it by +2 or -2.
Example: A user code
367
Code
another user.
5
- 2 =
Reason: In other models of the code lock, this is used, e.g. to signal an attack
(not possible with this code lock because the associated electronics are not
installed). The idea behind this is that the code input of the wrong code will
open the door, but also raise an alarm. As mentioned above, this function is not
available with this code lock.
In principle the relay in the code lock is opened by codes with the first digit
differing by +2 or -2 as well.
Example: A user code
The code
is no error, but due to the above situation.
42
567
767
or
3 5 7
or + 2 =
567
367
has been programmed.
can no longer be programmed for
was programmed.
767
or activates the relay as well. This