Nail Selection; Standard Accessories; Applications - HIKOKI NT 65M2 Mode D'emploi

English

NAIL SELECTION

Only nails shown in the Table below can be driven with this Nailer.
16 Gauge fi nish nails

STANDARD ACCESSORIES

(1) Case ............................................................................. 1
(2) Eye protector ................................................................ 1
(3) Nose cap (mounted on tool) ......................................... 1

APPLICATIONS

○ Nailing as fi nishing process for areas around the doors,
windows as well as edgings.
○ Securing the bottom of drawers. Making various cases
and cabinets.
PREPARATION PRIOR TO OPERATION
1. Prepare the hose
Be sure to use the hose provided with minimum 6 mm
(1/4") inside diameter.
NOTE
The air supply hoses must have a minimum working
pressure rating of 10.4 bar (150 psi) or 150 percent
of the maximum pressure produced in the air supply
system, whichever is higher.
2. Check on safety
CAUTION
○ Unauthorized persons (including children) must be kept
away from the equipment.
○ Wear eye protector.
○ Check the retaining screws which fi x the exhaust cover,
etc. for tightness.
Check the nailer for air leaks and defective or rusty
parts.
○ Check whether or not the push lever works correctly.
Also check whether or not any dirt has adhered to the
moving parts of the push lever.
○ Recheck on operational safety.
10
Min.
2.8 mm (.110")
1.4 mm
(.054")
Dimensions of nails
BEFORE USE
1. Check the air pressure
CAUTION
The air pressure must be constantly maintained at 4.9 –
8.3 bar (70 – 120 psi).
Adjust the air pressure between 4.9 to 8.3 bar (70 –
120 psi) according to the diameters and length of nails
and hardness of the wood being nailed. Pay special
attention to the output pressure, capacity, and piping
on the air compressor, so that air pressure does not
exceed the specifi ed limit. Note that excessive pressure
may aff ect overall performance, service life, and safety.
2. Lubrication
(1) Prior to operating this nailer, be sure to provide an
air set between the air compressor and this device.
Lubrication through the air set off ers smooth operation,
extended service life, and anticorrosion.
Adjust the oiler so that a single drop of oil is supplied at
intervals of 5 to 10 nailing cycles.
(2) It is recommended using the recommended oil (SHELL
TONNA). Other applicable oils are listed. Never mix two
or more types of diff erent oils.
3. Load nails
CAUTION
○ When loading nails into Nailer,
(1) do not depress trigger;
(2) do not depress push lever; and
(3) keep your face, hands feet and other body parts, as
(1) Pull the nail feeder until the concave portion of the
magazine cover clicks. (See Fig. 2)
(2) Insert nail strips one by one from above the magazine.
Slide nails forward in the magazine. (See Fig. 3)
(3) While holding the nail feeder adjust the magazine cover
in place. (See Fig. 4)
(4) Slide the nail feeder slowly forward until it contacts
nails.
1.65 mm
(.065")
well as those of other persons away from the nose
muzzle to avoid possible injury during usage and
carrying.
Max.