Auto Compensation - arjo Enterprise 9000X Notice D'utilisation

Weighing To calculate and display the patient's weight:
1. With the patient lying centrally on the bed, press the Weigh
2. The display will show a moving circular pattern until a stable
3. The patient's weight will be displayed for ten seconds then the
The patient's weight is usually displayed rounded to the nearest 500g; this
can be temporarily changed to 100g by pressing the Select Weight
Display button. The display will revert to 500g next time the Weigh button
is pressed.
NOTE
The 100g weight display should only be used for comparative readings.
Auto The Auto Compensation facility allows weight (up to a maximum of 100kg)
Compensation to be added to or removed from the bed, without affecting the indicated
patient weight.
1. With the patient lying on the bed, press the Auto Compensation
2. The display will show a moving circular pattern until a stable
3. The display will show
4. Add or remove accessories, bed linen, pillows, etc. as required.
5. Press the Auto Compensation button again.
6. The display will show a moving circular pattern for a few seconds
CAUTION
The weighing system requires periodic calibration to ensure accuracy. See
"Preventive maintenance" on page 49.
42
button once.
weight reading is obtained.
display will go blank.
button once.
weight reading is obtained.
Compensation mode.
then revert to showing the patient's weight..
to indicate that the system is in Auto