arjo Enterprise 9000X Notice D'utilisation page 31

Thigh section These buttons raise and lower the thigh section.
When the thigh section is first raised from the flat position, the calf section
will be in the Fowler position (angled downwards).
To change the calf section to the vascular (horizontal) position, refer to the
section "Adjusting the calf position" on page 36.
Backrest angle These buttons raise and lower the backrest.
Bio-Contour The Bio-Contour up button simultaneously raises the backrest and thigh
sections to provide upright patient profiling; the raised thigh section prevents
the patient sliding down the bed.
The Bio-Contour down button returns the mattress platform to a flat position.
Mattress These buttons raise and lower the mattress platform.
platform height
All sections will lower at maximum speed until the bed reaches low height
(40cm*) where it will continue to lower at half speed until it has reached extra
low height (32cm*).
(*Low height and extra low height dimensions are for reference only.)
NOTE
The mattress platform will not lower to extra low height if the bed platform is tilted
(in Trendelenburg or reversed Trendelenburg position).
WARNING
At minimum height, clearance underneath the bed is reduced. Keep your feet away
from the areas below the split side rails and take extra care when using patient hoists
or similar equipment.
31