Type-Identical Identification Marking; Use; Before Use - Dräger FPS 7000 Notice D'utilisation

Use

2.5

Type-identical identification marking

The facepieces have different markings:
Connector RA, P
EPDM or Si,
Facepiece body
EN 136:1998 CL.3+, CE0158
Size of facepiece
S (small), M (medium), L (large)
body
Size of nose cup 1 (small), 2 (medium), 3 (large)
PC, F (fire brigade), according to EN 166
A (ballistic protection class 190 m/s)
T (ballistic protection class at extreme
temperatures, tested at -22 °F to 140 °F
Visor (-30 C° to +60 °C) with 190 m/s)
PCas (coated with scratch-resistant material)
PCaf (coated with scratch-resistant material
on the outside, with anti-fog coating on the
inside)
Rubber harness CR or Si, M/L, or S
Hairnet H
216 (text approved by NIOSH, not approved by any other notified body)
3 Use
3.1

Before use

Strictly follow OSHA 1910.134 and other valid national regulations
for the use of respiratory equipment.
Before using the facepiece for the first time, perform a leak test
(see "Leak tests" on page 220).
3.1.1 Selecting the correct facepiece size
The facepiece bodies are available in sizes S, M, L, nose cups in sizes
1, 2, 3 and head harnesses in sizes M/L and S. In most cases, the
standard size M2 is used. If using size M2 cannot ensure sufficient leak
tightness, another size combination must be used.
WARNING
!
Each user must be provided with a facepiece of suitable
size.
Prior to use, always make sure that the facepiece is
leaktight. The face seal between head and facepiece body
must be free of hair and foreign substances which could
cause leakages. Spectacle wearers should wear facepiece
spectacles.
3.1.2 Preparing the facepiece for use
1. Install the facepiece spectacles if necessary
2. If fitted, remove the protective film from the visor.
3. Open the head harness as far as possible.
4. Put the neck strap around the neck and fasten the facepiece in
retrieval position (see Figure B on page 226).
1) Strictly follow the corresponding assembly instructions.
1)
.
Dräger FPS 7000