Technical Data; Battery Charging; Starting Operation - Bosch GAS 10,8 V-LI Professional Notice Originale

OBJ_BUCH-2136-002.book Page 10 Tuesday, November 18, 2014 10:32 AM
10 | English
11 Battery port
12 Battery unlocking button
13 Opening
14 Filter seal
15 Filter assembly
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.

Technical Data

Cordless dry vacuum cleaner
Article number
Container volume
Vacuum, max.
Airflow, max.
Weight according to
EPTA-Procedure 01/2003
Permitted ambient temperature
– during charging
*
– during operation and during
storage
Recommended batteries
Recommended chargers
* Limited performance at temperatures <0 °C
Technical data determined with battery from delivery scope.
Assembly

Battery Charging

 Use only the battery chargers listed on the accessories
page. Only these battery chargers are matched to the lith-
ium-ion battery pack used in your vacuum cleaner.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The lithium-ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
 After the automatic shut-off of the vacuum cleaner, do
not continue to press the On/Off button. The battery
pack could become damaged.
Observe the notes for disposal.
Battery Charge-control Indication
The three green LEDs of the battery charge-control indicator
3 show the charging status of the battery 5. The battery
charge-control indicator only illuminates for 3 seconds after
start-up.
1 609 92A 134 | (18.11.14)
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after switching on, then the battery is
defective and must be replaced.
Battery Insertion/Removal (see figures A1 – A2)
 Do not use force to insert the battery. The battery is de-
GAS 10,8 V-LI
signed in such a way that it can only be inserted into the
3 601 JE3 0..
vacuum cleaner when it is in the right position.
l 0.4
– Slide the battery 5 all the way into the battery compart-
ment 11.
hPa 45
– To remove the battery pack 5, press the unlocking buttons
l/s 15
12 and pull the battery pack out of the battery port 11.
kg 0.9
Mounting the Crevice Nozzle (see figure B)
 Remove the battery before cleaning or performing
°C 0...+45 maintenance on the vacuum cleaner, making tool ad-
justments, changing accessories or storing the vacuum
cleaner. This safety measure prevents the vacuum cleaner
°C –20...+50
from being started accidentally.
GBA 10,8V ...
The crevice nozzle 9 can be connected directly to the dust
AL 11..
chamber 8.
– Firmly insert the crevice nozzle 9 into the intake port 10 on
the dust chamber 8 with the mark shown in the illustration
facing down.
Operation
 Remove the battery before cleaning or performing
maintenance on the vacuum cleaner, making tool ad-
justments, changing accessories or storing the vacuum
cleaner. This safety measure prevents the vacuum cleaner
from being started accidentally.

Starting Operation

 Before vacuuming, ensure that the filter assembly is
assembled securely.
 Only use an undamaged filter (no cracks, small holes,
etc.). Replace a damaged filter immediately.
Switching On and Off
To save energy, only switch the vacuum cleaner on when us-
ing it.
– To switch on the vacuum cleaner, press the On/Off button
2.
– To switch off the vacuum cleaner, press the On/Off button
2 again.
Capacity
≥2/3
≥1/3
<1/3
Reserve
Bosch Power Tools