Technical Data; Mounting The Handle - Bosch GAS 50 M Professional Notice Originale

Masquer les pouces Voir aussi pour GAS 50 M Professional:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
16 | English

Technical Data

Wood vacuum cleaner
Article number
Rated power input
Container volume
(gross)
Net volume
Dust bag contents
Vacuum*
Airflow*
Suction capacity
Surface of folded filter
Dust category (BIA)
Weight according
to EPTA-Procedure
01/2003
Protection class
BIA test certificate
number
* measured at the blower
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your vacuum cleaner. The trade names of the individual
vacuum cleaners may vary.
1 609 929 K11 | (18.2.09)
All manuals and user guides at all-guides.com
GAS 50 M
Professional
0 601 988 1..
W
1200
l
50
l
43
l
21
mbar
225
l/s
39
W 316 (6 mbar)
2
cm
8600
M
kg
17.4
/I
200220710/
1110
Assembly
Before any work on the vacuum cleaner it-
self, pull the mains plug.

Mounting the Handle

The vacuum cleaner cart is designed in such a
manner, that the vacuum cleaner can be pushed
easier with the push handle 16. Always grasp
the push handle 16 with both hands when push-
ing the vac.
Insert the push handle 16 into the 2 openings of
the container 11. Push the clamps 15 through
the corresponding holes of the push handle 16
and then lock the clamps 15.
The casters are equipped with brakes 12. To ac-
tuate the castor brake 12 press the lever down-
wards.
Replacing/Inserting the Dust Bag
(see figure A)
– Unlock the latches 13 and remove the vacu-
um lid 3.
– Pull off the full dust bag 17 from the connec-
tion flange toward the rear. Close the open-
ing of the dust bag by folding down the lid.
Remove the closed dust bag from the vacu-
um cleaner.
– Slide the new dust bag 17 over the connec-
tion flange of the vacuum cleaner. Make sure
that the full length of the dust bag 17 faces
against the inner wall of the container 11.
Reattach the vacuum lid 3.
– Lock the latches 13.
For dry vacuuming operation, a dust bag 17
should be inserted. When operating with a dust
bag 17, the folded filter 18 clogs slower, the vac-
uuming performance is kept up longer and the
disposal of dust becomes easier.
When materials not hazardous to one's health or
materials with or without an exposition value of
3
≥ 1 mg/m
according to dust category L (until
now application category U) are being vacu-
umed, it is possible to vacuum directly into the
container.
Bosch Power Tools

Publicité

Table des Matières
loading

Table des Matières