Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-1321-001.book Page 12 Thursday, January 13, 2011 2:35 PM
12 | English
Intended Use
The machine is intended for collection, vacuum-
ing, conveying and separation of non-flammable
dry dusts that correspond with the general ex-
position limit value of > 1 mg/m
of mineral materials with aluminium hydroxide,
graphite dusts, aluminium dusts, paper dusts,
soot dusts, powder paint dusts, polyurethane
dusts, GFRP dusts based on epoxy resin (see
manufacturer's data sheet on safety), CFP dusts
based on epoxy resin (see manufacturer's data
sheet on safety), varnish dusts without carcino-
genic components, wood dusts and non-flam-
mable liquids and water-air mixtures. The vacu-
um cleaner is dust-technically checked and
corresponds with dust category L.
The vacuum cleaner has a blower function, e. g.
for drying surfaces.
The vacuum cleaner has a socket outlet with re-
mote automatic switching for connection of a
power tool with extraction function.
It is suitable for the increased demands of in-
dustrial usage, as required in trades, industry
and workshops.
The vacuum cleaner may generally not be used
in rooms where the danger of an explosion ex-
ists.
Technical Data
The technical data of the machine are listed in
the Table on page 166.
Mounting and Operation
Action
Removing accessories
Mounting the hose holder
Inserting a dust bag
Inserting a disposal bag
Disposing of the dust bag
Mounting the hose
Transport position
1 609 929 X19 | (13.1.11)
The values given are valid for a nominal voltage
[U] of 230 V. For different voltages and models
for specific countries, these values can vary.
Please observe the article number on the type
plate of your vacuum cleaner. The trade names
3
, such as dusts
of the individual vacuum cleaners may vary.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical data" is
in conformity with the following standards or
standardization documents: EN 60335 and the
directives 2006/42/EC, 2004/108/EC including
their amendments.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
09.12.2010
Noise Information
The measured values of the machine are listed
in the table on page 166.
Measured values determined according to
EN 60704.
Dr. Eckerhard Strötgen
Head of Product
Certification
Figure
Page
1
167
2
167
3
168
4
169
5
169
6
170
7
171
Bosch Power Tools
Publicité
Table des Matières
