Power Supply Of Detector - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

 o.o.b - Out of beam display: On/OFF
Default: OFF. Switch Out-of-beam display on and off. A sequence
of arrows indicates if the detectorhas moved beyond the vertical re-
ception range and will indicate in which direction to move to get
back to the laser beam.
 Inf - Device Information
Find Information about Firmware Version (Fw), Device Code (dc)
and Serial Number (Sn) here.
 ALG – Detector alignment for ALIGN - function
Default: "Hor"  "UP" / "Ver"  "UP". Setting "UP" und "dwn" pos-
sible.
Setting "UP" horizontal: Text „THEIS" of Logo upright readable
Setting "UP" vertical: Text „TE 90 ALIGN" upright readable
NOTE: All menu settings will be retained when the detector is
turned off.

11.3 Power supply of detector

If the battery symbol is shown on the LCD display, you should change
the battery (1xAA); otherwise, the range may be limited.
Open the folding lid of the battery compartment to change the battery.
Dispose of used batteries correctly (see point 22) and ensure the cor-
rect polarity with the new batteries (observe the symbols).
51