Horizontal Operation; Vertical Operation/Alignment Mode - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

1.
Align the tripod and screw the VISION tight using the
tripod screw. The precision of alignment affects the
size of the slope range. Use the On/Off switch to
switch on the device.
The levelling indicator flashes on the lit display.
If the tripod head is sloping by more than 5°, this is
indicated by the laser beam flashing quickly and the
alarm symbol being displayed.
In this case, switch off the unit and align the tripod
more carefully.
Once horizontal levelling is completed, the laser
beam starts to rotate.
2.
Set up the laser or fasten it to the tripod such that the
keypad is facing upwards. If necessary, use the
5/8"nut to screw it on the tripod. Use the On/Off
_ _ _
button to switch on the laser. For more information,
refer to point 1.
Use the arrow keys to align the laser beam. Pressing
the arrow key and holding it down speeds up
alignment of the laser beam.
_ - _
If the traverse path is exceeded while aligning, this is
indicated by a change in the arrangement of the
bars, by a quickly flashing warning symbol and by
the laser beam.
- _ -
You can clear the end stops again using the arrow
keys.

Horizontal Operation

Vertical Operation/Alignment Mode

39