Slope In Manual Mode - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

4.3 Slope in Manual Mode

To be able to set higher grades using a level table
or to record building-side specified grades, for ex-
ample, you must switch off the device's automatic
system.
You do this by pressing the On/Off key for a long
time (approx. 5 sec.) Manual mode is shown on the
display.
Now align the laser exactly to the target point using
a sighting telescope or the optical sight and enter
the grade:
1st key press: Slope symbol and X is shown on the
X
display.
Use the arrow keys to approach the slope.
2nd key press: X - Symbol disappears but slope
symbol and Y is shown in the display.
Y
Use the arrow keys to approach the slope.
You can set both PLUS and MINUS grades. While
you press the bottom arrow key, MINUS is shown
on the display. With the top (Plus) arrow key, there
is no indication on the display.
Important: In manual mode, there is no auto-
matic laser self-levelling and AUTOSLOPE moni-
toring is deactivated!!!
42