Slope In Manual Mode - THEIS VISION 2N AUTOSLOPE Instructions De Service

Afterwards align the beam with the arrow keys to the
target. Meanwhile the slope symbol is blinking.
Attention: The values in the display will start to increase
slowly and speed up than.
When the target point is reached, confirm with button
x/y (short key press).
The automatically observation of the slope is activated
(AUTOSLOPE – Function).
After some seconds the slope symbol and additionally
ALIG will be displayed permanent.

5. Slope in Manual Mode

To be able to set higher grades using a level table or to
record building-side specified grades, for example, you
must switch off the device's automatic system.
You do this by pressing the On/Off key for a long time
(approx. 5 sec.) Manual mode is shown on the display.
Now align the laser exactly to the target point using a
sighting telescope or the optical sight and enter the
grade:
1st key press: Slope symbol and X is shown on the
X
display.
Use the arrow keys to approach the slope.
2nd key press: X - Symbol disappears but slope symbol
Y
and Y is shown in the display.
Use the arrow keys to approach the slope.
You can set both PLUS and MINUS grades. While you
press the bottom arrow key, MINUS is shown on the
display. With the top (Plus) arrow key, there is no indi-
cation on the display.
30