Horizontal Operation - THEIS VISION 2N AUTOSLOPE Instructions De Service

1. Horizontal Operation

Align the tripod and screw the VISION tight using the
tripod screw. The precision of alignment affects the size
of the slope range. Use the On/Off switch to switch on
the device.
The levelling indicator flashes on the lit display.
If the tripod head is sloping by more than 5°, this is
indicated by the laser beam flashing quickly and the
alarm symbol being displayed.
In this case, switch off the unit and align the tripod more
carefully.
Once horizontal levelling is completed, the laser beam
starts to rotate.
2. Rotationsgeschwindigkeit
The rotation speed can be regulated in four stages: 0,
200, 600, 800 and 1000 RPM. Pressing the rotation key
three times the laser stops (0 RPM). Each time you
press the key again, the rotation speed increases.
At a standstill, you can move the laser dot using the
counterclockwise/clockwise rotation keys. Pressing and
holding down one of the keys speeds up the movement
of the laser dot.
27