Slope - Align - Function - THEIS VISION 2N AUTOSLOPE Instructions De Service

Once the values have been reached, the slope settings
and the slope symbol are displayed permanently lit.
If external influences change the position of the device,
the Autoslope monitoring system registers this and
automatically initiates adjustment. If the device is tilted a
relatively long way, the system interrupts rotation and
the laser beam and the warning display flash rapidly.
If you press the slope key again, you can start grading
again, the device carries out levelling again and
approaches the stored slope settings again.
Important: The laser's mounting position and
possibly also the elevation and direction may,
however, have changed. This means that to be on
the safe side you should switch the device off and
back on again and adjust it.
4. Slope – Align – Function
During Slope-Align-function the laser beam can be in-
clined to a given slope. This will be effected by the radio
remote control FB-3. Subsequently an automatically ob-
servation of the laser level will start with the Autoslope-
system.
First adjust the laser as mentioned under pt. 3. Press
the slope button on remote control long time (5 sec)
while the instrument is switched on.
All buttons of the laser – except of ON/OFF – are
blocked now.
As long as the level is blinking, the laser is levelling au-
tomatically.
y- is blinking in the display.
Y
While the level is on permanent, don't touch the laser.
The indicated slope values could otherwise be incorrect.
29