Operation - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

11.2 Operation

Switching the device on / off
Press the On / Off button
Adjusting the volume
Pressing the audible signal button cycles Low / High / Off
 High: Display of audible signal permanently displayed;
text "Hi" for one second
 Low: Display of audible signal permanently displayed;
text "LOW" for one second
 Off: No Display of audible signal displayed;
text "OFF" for one second
Adjusting the accuracy
Press accuracy button once to numerically display current accuracy
setting on the LCD. Press again, while the accuracy is displayed
(within one second), to change the current selection. Subsequent
presses will cycle through five accuracy options Ultra fine / Fine /
Medium / Coarse / Ultra coarse.
Ultra fine
Fine
Medium
Coarse
Ultra coarse 10.0
Table 1: Accuracy
Activate / deactivate LEDs
Press the LEDs On-Off button to change the LED display. If activat-
ed, the measurements are shown by the LEDs in addition to the
display.
mm cm inch
0.5 0.05 0.02
1.0 0.1 0.05
2.0 0.2 0.1
5.0 0.5 0.2
1.0 0.5
Fract.In.
-
1/8
1/4
1/2
-
49
Display
flashing
non- flashing
non- flashing
non- flashing
flashing