Radio Remote Control Fb-V (Option) - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

10. Radio Remote Control FB-V (Option)

The wireless remote control is designed on a bidirectional basis. All
the information that is shown on the laser's display can also be
seen on the lit-up display of the remote control. The key symbols on
the operator panel correspond to the keys on the laser keypad. The
MANUAL operating mode is missing to ensure that it is not
possible to enter this function by mistake.
Die FB-3 durch Drücken einer beliebigen Taste einschalten. Die
Switch on the FB - V by pressing any key. The remote control
automatically searches for an appropriate channel to rule out
disturbances to other devices.
On the display, you can see the same information as on the display
of the associated laser. If this is not the case and an antenna
symbol is displayed, this may be due to one of the following
reasons:
- The laser is not switched on
- The radio channel is not set correctly
- The remote control is out of range of the laser.
Pressing both arrow keys switches off the laser. The FB - V
switches itself off after 1 minute.
If the Standby-/Sleep-function is activated to save the capacity of
the battery (see capital 14), the laser can be set in standby-mode
by pressing both arrow-buttons on the remote control. With any
46