Power Supply Of Laser - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

Power Supply of Laser

9.
The battery level indicator shows the battery status in
four steps.
If the three bars on the display are blank and the
outside frame flashes, the battery is flat and you
must charge it. If you do not notice this, the device
switches off automatically after a certain amount of
time.
During charging the three bars flash from top to
bottom. When the battery is fully charged, all the bars
are shown.
Charge the battery at room temperature using only
the THEIS standard mains unit connected to the
charger socket below the laser. Charging at
temperatures below +5°C can lead to defects in the
battery.
Charging is also possible during operation.
Overloading is not possible.
Only use the charger on dry premises!
The batteries that are used with Eneloop™
technology have the advantage of low levels of
self-discharge. This means that if you do not use
the device, you only need to recharge it every six
months.
In the battery compartment, you can also use normal
alkaline mono-cells. Under no circumstances must
you recharge them. If you do this by mistake, the
battery symbol flashes.
Important: Observe the correct polarity. There
are ± symbols on the base of the battery
compartment. Observe the disposal information
in point 22.
Important: Because the battery poles and con-
tacts may soil over time, resulting in contact
problems, regular inspection and possibly clean-
ing with a soft cloth and cleaning agent (spirit,
alcohol) are necessary.
45