Driving The Scooter Over Obstacles; Operator Control - Vermeiren Eris Manuel D'utilisation

Should you wish to use ramps to drive over an obstacle, please note the following:
1. Find out from the manufacturer what the maximum load is for the ramps.
2. Drive on the ramps at the lowest speed possible.
3. See the instructions in the chapter "your first trip".
2.9

Driving the scooter over obstacles

L
WARNING:
Risk of injuries by unexpected movement

Do not use your scooter on an escalator.

Do NOT drive on slopes, obstacles, steps or kerbs larger than the size described in the
technical specification in §1.3.

Approach a kerb always from the front.

Make sure that all wheels make contact to the ground during driving up or down.
L
CAUTION:
Risk of damage
If necessary, take a short run up to speed-up the scooter to mount the obstacle or kerb.
Prevent that you or your scooter has to cope with a large recoil.

2.10 Operator control


Put the ON/OFF key switch on, please wait for at least 3 seconds before you press the speed
lever otherwise you have a "delay protection" alarm.

Now the battery level indicator

Now turn the speed switch

Pull the drive lever with your fingers backwards (right lever for forward movement, left lever for
backward movement).

To sound the horn, press the horn button

To put on the front and back lights, press the light button

To put on the emergency flashers, press button

To put on the indicator lights, press the desired button
indicator).

To stop the scooter loosen the speed lever under the operator control.
3
8
5
Vermeiren is responsible for the changes in the software. For changes in the software contact
Vermeiren.

will light up and shows the current level of your batteries.

to the desired driving speed.

.
1
2
7
4
Page 15

.

.
 
and (left = left indicator, right = right
6
1 = Trouble indicator
2 = Speed switch
3 = Head Lights
4 = Horn
5 = Indicator (left)
6 = Emergency lights
7 = Indicator (right)
8 = Battery level indicator
Eris
2019-03