Operating The Brakes; Mounting Or Removing Of Armrests; Transfer In And Out The Scooter; Correct Position In The Scooter - Vermeiren Ceres 3 Mode D'emploi


Mount the seat (see "Adjusting the seat" chapter) and the armrests (see "Mounting or removing of
armrests" chapter).
2.4

Operating the brakes

To apply the brakes:
1. Let go of the speed or drive lever to stop the scooter.
2.5

Mounting or removing of armrests

L
CAUTION:
Risk of clamping – Keep fingers, buckles and clothes away from the
attachment point (on the tube of the seat frame) of the armrest.
To mount the armrest on the scooter:
1. Slide the tube of the armrest in the tube of the seat frame.
2. Push on the tube of the armrest until the desired seat width.
3. Mount the star knob on the back of the scooter.
The armrest of the scooter can be taken off.
1. Remove the star knob on the back of the scooter.
2. Pull on the tube of the armrest.
3. Slide until the tube comes out the tube of the seat frame.
2.6

Transfer in and out the scooter

2.7

Correct position in the scooter

Some recommendations for a comfortable use of the scooter:
1. Position your backside as close as possible to the back rest.
2. Make sure your upper legs are horizontal – If needed adjust the seat height.
2.8

Driving the scooter

L
WARNING:
Risk of burns – Be careful when driving in hot or cold environments
(sunshine, extreme cold, saunas, etc.) for a sufficient amount of time and when
touching - Surfaces can assume the environment temperatures.
L
WARNING:
Risk of unsafe settings - Use only the driving characteristics described in
this manual.
2.8.1 Preparing the scooter for use
When you use your scooter for the first time, make sure that it is standing on level ground. All wheels
must be in contact with the ground.
1. Make sure that the motor is engaged.
2. Set the seat at a height best suited to yourself.
3. Set the steering unit in the most comfortable position for yourself.
4. Sit down on the seat and verify that both armrests have been adjusted so your forearms are
folded down.
5. See that the seat has been locked in the driving position.
6. Insert contact key and turn to the right.
1. Park the scooter as close as possible to the place where you
want to transfer.
2. Check that the operator control is switch off.
3. Put the armrest on the side you want to transfer upwards.
4. Transfer to / from the seat of the scooter.
Page 11
Ceres 3, Ceres 4
2015-03