Operating The Buzzer; Angle Adjustment Led Light; Height Adjustment Walking Stick - Vermeiren Electra Mode D'emploi


Close the flap  on the backside of the
handgrip , by moving the locking
mechanism downwards.
-
+
-
+
7. Operating LED
warning light
To operating the LED light and warning light
use instructions below:

Press once on the button , the LED
light lit.

Press again or twice on the button , the
LED light and warning light lit at the same
time.

Press again or three times on the button
, the LED light and warning light goes
out.

8. Operating the buzzer

To operating the buzzer use the instructions
below:

Press the panic button , the buzzer
shall be activated.

Press the panic button again  to turn
the buzzer off.

9. Angle adjustment LED light

It is possible to adjust the angle of the LED
light with the instructions below:

Grasp the LED light with your hand.

Move these downwards or upwards until
the desired angle (4 positions: 0° / - 15° /
- 30° / -45°).

10. Height adjustment walking stick

L
light and
Before using the walking stick you must adjust
these in the correct height.
Adjust the height of the walking stick
according following instructions:
1. Unscrew the anti-noise ring .
2. Press on the spring pin .
3. Pull / push the lower tube  until the
4. Check that the spring pin  is good
5. Tighten the anti-noise ring  again firmly.
3
CAUTION: Risk of falling -
Check that the spring pins  are good
clicked back.
desired height (10 different positions:
increments of 25 mm).
Ensure that the height of your wrist is at
the same height of the handgrip when
you leave your arms loose next your
body. Ensure that your body is in an
upright position.
clicked back.
Electra
2016-08