Operating The Brakes; Transfer In And Out The Wheelchair - Vermeiren Bobby Manuel D'utilisation

3.3

Operating the brakes

WARNING
 The brakes are not used to slow down the wheelchair during
movements. Use the brake only to prevent the wheelchair from
unintended movements.
 Good operation of the brakes is influenced by wear and
contamination of the tires (water, oil, mud, ...). Check the
condition of the tires before each use.
 The brakes are adjustable and can wear. Check the operation
of the brakes before each use.
 Make sure the wheelchair is on a flat horizontal surface before
releasing the brakes.
simultaneously.
The brakes can only be activated by the attendant.
To apply the brakes:
1. Pull the brake levers (1) upwards.
2. Push on part (2) to block the brakes.
To release the brakes:
1. First release part (2).
2. Release the brake levers (1).
3.4

Transfer in and out the wheelchair

WARNING
 In case you cannot perform the transfer in a safe manner, ask someone to assist you.
 Do not stand on the footplates.
1. Position the wheelchair as close as possible to the chair, couch or
bed to/from you wish to transfer.
2. Check both brakes from the wheelchair are in the on position.
3. Fold the footplates upwards to prevent standing on them.
4. Transfer to/from the wheelchair.
3.4.1 Correct position in the wheelchair
Some recommendations for a comfortable use of the wheelchair:
 Position your backside as close as possible to the backrest.
 Make sure your upper legs are horizontal. If needed, adjust
the length of the footrests (see § 4.3).
Risk of injury
Never release
Risk of injury and/or damage
both brakes
7
EN
Bobby
2022-07
Using your wheelchair
NL