Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.2.4 Date and Time
You should set the date and time prior to initial use of the torque
wrench with built-in angle gauge and after storing without batter-
ies so that data is stored with the correct date and time.
Select the „Date/Time" menu option as described in 7.2.2. The
date and time are displayed. Use
highlighted. Change to month, year, hour, etc. by pressing
NOTICE! The date/time settings are only saved if you
move through all the numbers with
leave the menu option by pressing
Please refer to the menu structure on pages 8 and 9 for other
adjustable settings.
7.3 Unit
If you want to program your torque wrench with built-in angle
gauge using a different unit of torque, you must first modify the
unit of torque and then the required torque values in the corre-
sponding menu options.
ATTENTION! Multiple changes in unit without chang-
ing the torque values may cause deviations in rounded
values.
Go to the "Unit" menu option to select the unit of torque that you
wish to use for programming the torque values and displaying the
measurement results.
Select the "Unit" menu option as described in 7.2.2. Set the
highlighted unit by pressing
7.4 Effective lengths:
The depth gauge l
entered under the "Effective length" menu option.
Please refer to the relevant illustrated list for depth gauges of the
HAZET plug tools.
ATTENTION! If the effective length programmed does
not match the effective length of the plug tool used,
there will be a discrepancy between the torque value
shown on the display and that applied to the screw
joint.
1. To adjust the effective length, change to the menu with
and select the "Effective length" menu option with
2. After selecting the "Effective length" menu option with
you can adjust the effective length of the plug tool used
with
or
.
3. Confirm the entered value with
26
Design and function
to change the value
.
and confirm by pressing
of the plug tool must be
w
.
8 . Programming
The last programmed settings are displayed when the
wrench is switched on. The display of individual modes
is as follows:
• Mode torque, track mode
.
and
• Mode torque, peak mode
• Mode torque, peak mode with control of rotation angle
(only TOP version)
.
• Mode rotation angle
• Mode rotation angle with torque control
(only TOP version)
• Workflow with parameter (only TOP version)
.
Mode:
The "Mode" menu option allows you to set whether you wish to
work with tightening method "Torque" or "Rotation angle". The
selection is as described in 7.2.2.
Publicité
Table des Matières
