Intended Use - Hazet-Werk SYSTEM 7000 eTAC Notice D'utilisation

3 . Intended use

• Operational reliability can only be ensured, if the tool is
used as intended and in compliance with the indications
given in the operating instructions. Any deviation from the
intended use and/or any misapplication of the tool set is not
allowed and will be considered as improper use.
• Always ensure tools are used, inspected and maintained
in compliance with the respective local, state, national or
federal regulations.
• Torque wrenches with built-in angle gauge from HAZET
are designed solely for controlled tightening and undoing
of screw joints.
• The wrench is not intended to be used as a lever tool,
clamping tool or impact tool under any circumstances.
Incorrect use, use whilst failing to comply with the safety
instructions and overloading of the HAZET torque wrench
with built-in angle gauge can result in incorrect readings
and/or failure of the system (and thus death, serious injury,
health problems and material damage).
• Torque wrenches with built-in angle gauge are calibrated
measurement tools and must be handled accordingly with
due care. Avoid any mechanical, chemical and thermal
exposure that go beyond the stresses of normal use. The
torque wrench with built-in angle gauge must never be
exposed to rain or moisture or immersed in liquids. Do not
allow any foreign bodies to penetrate it and always ensure
that any unused connectors are covered. Extreme climatic
conditions such as cold, heat and air humidity can have an
effect on measurement values/results. Failure to comply
with these instructions can result in (irreparable) damage to
the torque wrench with built-in angle gauge.
• Incorrect use of the product tools or use whilst failing to
comply with the safety instructions can result in serious
injury.
• Any deviation from the intended use and/or any misappli-
cation of the tool is not allowed and will be considered as
improper use.
• Before using the device, check that the insert used and/or
the plug tool are/is seated firmly. Position the tool so that
it cannot slip from the screw joint. This poses a hazard to
persons and a risk of material damage.
• When using inserts or plug tools, ensure their design
conforms to standards and that their shape and size are
correct for the screw joint to be tightened.
• Also adhere to the maximum permitted load for the insert
or plug tool used. This can be lower than the achievable
release torque for the torque wrench with built-in angle
gauge. Custom-made tools can be dangerous and may
not be used. Failure to comply can result in injury and/or
material damage.
• Any claims against the manufacturer and/or its authorised
agents because of damage caused by improper use of the
tool are void.
• Any personal injury or material losses caused by improper
use of the tool are the sole responsibility of the owner.
20

For your safety
• Never modify the tool. For safety reasons, any modification
• The maximum permitted torque may not be exceeded in
• Users must maintain a safe, balanced position when
• Only use the tools at places that are governed and regu-
• Any claims against the manufacturer and/or its authorised
4 . Dangers that may arise from
the tool
of the HAZET electronic torque wrench with built-in angle
gauge is strictly forbidden. Safety devices and/or cover
parts may not be removed. Never operate the tool when
a protective cover is missing or when not all of the safety
devices are fitted and in perfect condition.
either direction of operation. All indications concerning
threshold values, setting values and setting ranges must
be observed.
working.
lated by applicable provisions for work areas.
ATTENTION! Do not use in environments susceptible
to explosions
agents because of damage caused by improper use of the
tool are void. Any modification of the tool and/or improper
use will result in immediate exclusion from warranty and
liability. Any personal injury or material losses caused by
improper use of the tool are the sole responsibility of the
owner.