Food Preparation - Teesa TSA3030 Manuel D'utilisation

20
1. Prior to first use, clean the parts of the device that will come in contact with food; and
dry the device afterward.
2. Place the food on food trays.
3. Place the food so it does not block the air flow.
4. Place the food trays on the base.
5. Place the top lid. Top lid HAS TO BE ON the appliance during the whole period of the operation.
6. Plug the appliance to mains supply, turn it on by switching the power supply button to
ON position; The power supply button will be back lighted in red. Set the dehydrating
temperature.
7. After you have finished working on the appliance, turn it off by switching the power
supply button to OFF position and disconnect it from mains supply.
Suggested dehydrating temperatures:
Herbs: 50°C
Bread: 50°C
Mushrooms: 50-70°C
Vegetables: 50°C
Fruits: 50°C-60°C
Note:
Dehydrating time presented in this manual are only for reference. Dehydrating time depends
on temperature and humidity of the room, humidity of the food, their thickness, etc.
EN
Containers for storing dehydrated products should be clean and dry.
Before dehydrating, follow the below steps:
1. Wash the food.
• Note: do not place wet food into the appliance; dry them with paper towel beforehand.
• Do not place wet food trays into the appliance.
2. Remove redundant food parts (e.g. hull, cut out cores, etc.).
3. Slice food and place on the trays so they do not block the air flow.
• Dehydrating time depends on thickness of the food pieces.
• To shorten the preparation time, shuffle the trays positions. Move top trays to the
bottom while bottom trays to the top. Some fruits consist of natural coating, which
will prolong the dehydrating process. In order to avoid that, put the food into boiling
water for about 1-2 minutes before processing them in food dehydrator, then place
them into cold water and dry (e.g. with paper towel).
Warning:
BE CAREFULL WHILE OPERATING THE APPLIANCE, AS HOUSING OF THE DEVICE MAY BE HOT.
DEHYDRATING

FOOD PREPARATION

Owner's manual