Performing The Pressing Operation - NovoPress AXI102 Manuel D'utilisation

Pos : 46 /RVT/Inbetri ebnahme und Betrieb/Ver press en/00c - Verpr ess en kompl ett AAP102 @ 0\mod_1387198591609_18.doc x @ 1752 @ 2 @ 1

9.2 Performing the pressing operation

CAUTION!
Faulty pressing!
Dirt, swarf, etc. in the contours of the pusher adaptors leads to a risk of faulty pressing.
Therefore:
–
Information!
To align the tool with the pipe, compliance with the system manufacturer's instructions
is essential.
1. Place the pusher tool on the joint to be pressed in accordance with information from the system
manufacturer.
CAUTION!
Danger of crushing by moving parts
Fingers risk being crushed.
Therefore:
–
Information!
The pusher tool must be held in the aligned position during the entire pressing
operation.
2. Press the start button and hold it until the pressing process is complete.
Pos : 47 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
Ensure that there is no dirt, swarf, etc. in the contours of the pusher adapters.
Keep all body parts and foreign objects away from the operating zone.
21
AXI102 / AAP102
EN