Technical Data; Push Button Panel (Saes); Preparing The Machine; Unpacking - Astoria GRETA AEPS Manuel D'utilisation Et D'entretien

4.2

Technical data

The nameplate of the machine is fixed on the
base of the frame under the drain pan.
The data of the appliance can be seen also on
the label located on the package of the machine.
Power supply voltage
Absorbed power
Water tank capacity
Safety valve calibration
Boiler operating pressure
Feedwater pressure
Coffee dispensing pressure
Dimensions: LxPxH
Operating conditions
4.3

Push button panel (SAES)

2 espressos
1 espresso 1 Large coffee
User manual
Technical data plate
V 230/240
W 2.600
L / gal UK 4 / 1.06
bar / psi 1.9 / 27.6
bar / psi 0.8-1.4 / 11.6-20.3
1.5-5 (MAX) /
bar / psi
21.8-72.5 (MAX)
bar / psi 8-9 / 116-130.5
cm 39 x 48 x 61
°C / °F 5-40 / 41-104
2 Larges coffees
Stop/
Programming
Stop
Prog.
5

Preparing the machine

The preparation of the machine and the instal-
lation operations must be carried out by qualified
personnel only. The installer must strictly follow
the indications provided in chapter: "Warnings for
the installer".
!
Using the machine without all the installation
operations having been carried out by technical
personnel could damage it seriously.
!
The machine must be placed in a perfectly
horizontal position.
5.1

Unpacking

• Open the package, remove the internal protec-
tive materials and extract the machine;
• after removing the packaging, check the condi-
tion of the appliance. If in doubt, do not use it
but contact the retailer directly.
5.2

Positioning

Place the machine on a support base which is
suitable for correct and convenient use of the cof-
fee machine.
5.3
Hydraulic connection to the internal
tank (if present)
• Fill the tank with potable water;
• periodically check the level of water in the tank
and refill as required.
Greta
29