System Master Sheet; Manufacturer; Purpose - ATT Nussbaum SMART LIFT 2.30 Manuel D'exploitation

2

System master sheet

2.1

Manufacturer

Nussbaum Custom Lifts GmbH
Hertz Str. 6
D-77694 Kehl-Sundheim
2.2

Purpose

The lift is a lifting tool for raising vehicles with a total weight of (* see list) in normal workshop operation at a
maximum load distribution of (2:3**) (1:3***) in or against the drive-in direction A single load from only one
or two lifting arms may not happen.
Set up of the standard lift in explosion and fire endangered workshops and humid spaces
(e.g. washing halls) is prohibited.
Lift operation is done directly on the operating column (see Data sheet).
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards
by a specialist who approves the changes. If the set up location is changed, the lift must be checked
again by a specialist and changed approved.
(*)System load of the SL series (SL = SMART LIFT):
• SMART LIFT 2.30 SL / HYMAX S 3000** = 3000 kg
• SMART LIFT 2.35 SL / HYMAX S 3500** = 3500 kg
• SMART LIFT 2.40 SL / HYMAX S 4000*** = 4000 kg
Lifting arm variants
Standard arms
MINI-MAX arms (MM)
DT Lifting arm
Sport Cars Lifting arm
(SC)
OPI_SMART LIFT 2.30 SL-2.35 SL-2.40 SL_V3.1_DE-EN-FR-ES-IT
SMART LIFT 2.30 SL
HYMAX S 3000
590 – 900 mm
940 – 1495 mm
600 – 980 mm
1000 – 1480 mm
232SL28000TG
480 – 870 mm
940 – 1495 mm
–
SMART LIFT 2.35 SL
HYMAX S 3500
505 – 823 mm
940 – 1495 mm
–
570 – 1160 mm
940 – 1495 mm
590 – 865 mm
840 – 1380 mm
SMART LIFT 2.40 SL
HYMAX S 4000
570 – 1160 mm
1130 – 1840 mm
635 – 1065 mm
1130 – 1840 mm
–
–
77