Operating Principles, Model S33; Treatment Time; Basic Setting; Perm Treatment - exonda S32 Mode D'emploi

GB
36
9.

Operating principles, model S33

9.1

Treatment time

• The selected treatment time and temperature is the responsibility of the
qualified hairdressing staff.
Please also take note of the manufacturer's instructions for the products
used.
• Please remember that heat may reduce the development times of the prod-
ucts.
9.2

Basic setting

In the basic setting, the temperature is at level 4; all heating heaters are selected,
the hair length is set to short hair, the blowers are off and the Client button is at
normal. The basic setting is achieved:
- when the appliance is switched on
- automatically 10 minutes after the last treatment.
- manually by pressing the CLEAR button.
9.3

Perm treatment

1. Enter the desired development time using the Time selection buttons and
start the appliance using the CARE + PERM button.
- The program starts at temperature level 4 and short hair length.
For perm treatments leave the setting at short hair length.
During the development time, the temperature sensor permanently
monitors the temperature at the client's head and automatically offsets
deviations from the optimal temperature.
2. The appliance switches off automatically after the development time has
elapsed. Now check your test roller to ascertain whether the desired perm
effect has been achieved.
3. If not, you can enter a chosen post-development time by pressing the Time
selection button.
4. Now restart the appliance using the CARE + PERM button.
9.4

Care

1. Enter the desired development time using the Time selection buttons and
start the appliance using the CARE + PERM button.
- The program starts at temperature level 4 and short hair length.
2. Set the appropriate hair length (short or long).
During the development time, the temperature sensor permanently moni-
tors the temperature at the client's head and automatically offsets devia-
tions from the optimal temperature.
3. The appliance switches off automatically after the development time has
elapsed. You can enter a chosen post-development time by pressing the
Time selection button.
4. Restart the appliance using the CARE + PERM button.
Operating principles, model S33