GB
30
DANGER! Risk of electric shock due to moisture
Even when the appliance is switched off at the main switch, the electrical
parts, as in most electrical appliances, are still live. As water is a very good
conductor of electricity, it is especially important to comply with the fol-
lowing safety instructions!
Protect the device from moisture, water drops and water spray.
The device, the cable and the mains plug must not be immersed in water or
any other liquids.
If liquid gets into the device, remove the mains plug immediately. Have the
device checked before reusing.
If the device has fallen into water, pull out the mains plug immediately, and
only then remove the device from the water. Do not use the device again, and
have it checked by a specialist.
Never touch the device with wet hands.
DANGER! Risk of electric shock
The wall arm version should only be used with a correctly earthed socket out-
let with earthing contact.
Do not use the device if the device or the power cable has any visible dam-
age, or if the device has previously been dropped.
Lay the power cable such that no one can step on it, get caught on it, or trip
over it.
Only connect the mains plug to a properly installed and easily accessible wall
socket whose voltage corresponds to the specifications on the rating plate.
The wall socket must continue to be easily accessible after the device is
plugged in.
Ensure that the power cable cannot be damaged by sharp edges or hot
points. Do not wrap the power cable around the device (risk of cable dam-
age!).
Ensure that the power cable cannot be trapped or crushed.
To pull the mains plug out of the wall socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall socket...
... after every use,
... if there is a fault,
... when you are not using the device,
... before you clean the device, and
... during thunderstorms.
To avoid any risk, do not make modifications to the product. You also must
not replace the power cable yourself. Repairs must be carried out by a spe-
cialist workshop or the Service Centre.
Never attempt to remove dust or foreign bodies from inside the device using
a pointed object (e.g. with a tail comb).
Safety information