For Proper And Long Use - Pioneer DVL-V888 Mode D'emploi

For Proper and Long Use

7 DO NOT MOVE THE UNIT DURING PLAYBACK
During playback, the disc rotates at high speed. Do NOT lift
or move the unit during playback. Doing so may damage the
disc.
7 WHEN MOVING THE UNIT
When changing places of installation or packing the unit for
moving, be sure to remove the disc and return the disc
table to its original position in the player. Then, switch the
power OFF. Check that the "OFF" indication on the display
goes off, then disconnect the power cord. Leaving a disc
loaded may result in damage when the unit is moved.
7 INSTALLATION PLACE
¶ Select a stable place to the side of a TV set or stereo
system to be connected to the unit.
¶ When using the unit with a stereo system, install the
speakers a little bit away from the TV.
¶ Do NOT install the unit on top of a TV or color monitor.
Install the unit away from equipment that may be affected
by magnetism, such as a cassette deck.
7 AVOID INSTALLING IN A PLACE THAT IS:
¶ Exposed to direct sunlight
¶ Exposed to humidity or where ventilation is poor
¶ Extremely hot or cold
¶ Exposed to vibration
¶ Exposed to dust
¶ Exposed to oily smoke, steam or heat (for example, a
kitchen)
7 DO NOT PLACE AN OBJECT ON TOP
Do NOT place an object on the unit.
7 DO NOT BLOCK VENTS
Do NOT use the player on top of a long-fibered carpet, bed or
sofa, and do not cover it with a cloth etc. This will prevent
heat radiation and could result in damage.
7 AVOID HEAT
Do NOT place the unit on equipment generating heat, such
as an amplifier.
When installing the unit in a rack, place it on the lowest shelf
possible (however, not where it is exposed to dust) and
separated from the amplifier to avoid the heat generated by
the amplifier or other audio equipment.
7 CAUTION: WHEN PLACING THE
UNIT IN A STEREO RACK WITH
GLASS DOORS
Be sure there is ample space between the unit and the
glass doors when opening the disc table using the remote
control.
If the disc table opens against strong resistance, such as
a closed glass door, damage to the unit may result.
7 SWITCH POWER OFF WHEN NOT US-
ING THE UNIT
Depending on the strength of the TV or radio broadcast signal,
having the TV or radio ON while power to the unit is ON may
result in stripes on the TV screen or noise. However, this is
not a malfunction of this unit or the TV or radio. In such a
case, switch power to the unit OFF.
When the DVD/LD player's audio output is connected to a
TV, VTR, or other component's audio input, excessively high
signal input from a mic when enjoying karaoke may result in
distortion and other adverse effects. If this happens, turn mic
volume down, or switch the Attenuator switch on the rear of
the player ON. (See P.70.)
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug
by tugging the cord and never touch the power cord when
your hands are wet as this could cause a short circuit or
electric shock. Do not place the unit, a piece of furniture,
etc., on the power cord, or pinch the cord. Never make a
knot in the cord or tie it with other cords. The power cords
should be routed in such a way that they are not likely to be
stepped on. A damaged power cord can cause a fire or give
you an electrical shock. Check the power cord once in a while.
When you find it damaged, ask your nearest PIONEER
authorized service center or your dealer for a replacement.

For Proper and Long Use

77