Maintenance Chart - DeWalt D55270 Guide D'utilisation

Masquer les pouces Voir aussi pour D55270:

Guide d'utilisation (52 pages)

Table Des Matières

Table des Matières

Les langues disponibles

6. Rotate manual lock unloader lever to the closed position to allow

air tank pressure to build. noTe: Pump will not operate with the

manual lock unloader lever in the open position.

7. Allow compressor to pump up to blow off pressure.

noTe: If any unusual noise or vibration is noticed, stop the compressor

and refer to the troubleshooting section.

noTe: The air compressor pump is capable of running continuously.

To prolong the air compressor's life, it is recommended to run at high

throttle 50-75% of the run time and idle for 5% of the run time

8. Attach hose and accessory.

CAUTION: Risk of unsafe operation. Compressed air from the unit

may contain water condensation and oil mist. Do not spray unfiltered

air at an item that could be damaged by moisture. Some air operated

tools or devices may require filtered air. Read the instructions for the

air tool or device.

9. Adjust regulator (F) to desired setting. See regulator under

Features.

Shut-down

1. Stop engine, see engine's instruction manual for correct

procedure.

noTe: If finished using compressor, follow Steps –6.

. Turn regulator knob (F) counterclockwise until fully closed. Ensure

regulated pressure gauge reads 0 PSI (0 kPa).

3. Remove hose and accessory.

4. Drain the air tank. See Draining Air Tank under Maintenance.

WARNING: Risk of bursting. Drain air tank daily. Water will condense

in air tank. If not drained, water will corrode and weaken the air tank

causing a risk of air tank rupture.

5. Allow the compressor to cool down.

6. Wipe air compressor clean and store in a safe, non freezing area.

MAInTEnAnCE

The following procedures must be followed when maintenance or

service is performed on the air compressor.

1. Ensure engine ON/OFF switch (C) is in the OFF position.

. Disconnect spark plug wire.

3. Drain air tank.

4. Allow air compressor to cool down before starting service

noTe: All compressed air systems contain maintenance parts (e.g.

oil, filters, separators) that are periodically replaced. These used parts

may contain substances that are regulated and must be disposed of in

accordance with local, state, and federal laws and regulations.

noTe: Take note of the positions and locations of parts during

disassembly to make reassembly easier.

noTe: Any service operations not included in this section should

be performed by a D

WALT factory service center or a D

authorized service center.