Setting Of The Ice Cube Height - Wessamat CombiLine W80 Manuel De L'utilisateur

User manual - English

Setting of the ice cube height

6.4
1. Switch off the machine at the production switch (Position "Produktion aus/off") and pull the
power plug. Remove the machine cover and the cover of the technical equipment box (marked
with a flash symbol).
2. Release the fixing screw of the water level sensor.
3. Change the position of the water level
sensor
Move upwards → longer ice cubes
Move downwards → shorter ice cubes
4. Tighten the screw, insert the power plug
and switch on the machine (Position
"Produktion ein/on") and monitor a produc-
tion cycle.
5. Switch off the
"Produktion aus/off") and pull the power
plug once the required ice cube height is
reached. Replace the electrics box and
housing cover and tighten the screws.
Re-start the machine.
IMPORTANT:
At the maximum setting of the water level sensor, ensure that no water spills over the edge of the
trough during the production cycle (during trough movement).
User-manual-CombiLine-W80-W120-W240-0299-2
machine (Position
Water level sensor
Abb. 6.4: Setting of the ice cube height
Tub
Seite 55