Trouble Shooting - Wessamat CombiLine W80 Manuel De L'utilisateur

User manual - English

Trouble shooting

7.6
Troubleshooting should only be carried out by a specialist or by service staff from an authorised
WESSAMAT specialist dealer.
Fault
Machine produces an
ice plate
Tub only tilts approxi-
mately one third or not
at all, and ice cubes are
not discharged
Tub tilts fully (contact
with limit switch
made) but immediately
returns to original posi-
tion
Storage container
overfilled with ice cubes
User-manual-CombiLine-W80-W120-W240-0299-2
Cause
1. Ice thickness motor
faulty, gearing no longer
rotating
2. Defective ice thickness
limit switch (limit contacts
are stuck or oxidised)
3. Tilting motor
(trough does no longer tilt)
4. Water level too high
(water in the
touches the
evaporator tubes)
1. The direction of rotation
of the tilting motor chang-
es under load
2. Tilting motor is faulty
Hot gas phase is too short
is
is Storage container thermo-
stat does not switch off
Trouble shooting measures
1. Replace ice thickness motor
2. Replace ice thickness limit switch
faulty
3. Replace tilting motor
4. Water level sensor soiled - clean
trough
or readjust probe
horizontal
1. Replace capacitor
2. Replace tilting motor
Check defrosting thermostat (switch
point at +17°C). Readjust the de-
frosting thermostat accordingly or
replace it.
Readjust storage container thermo-
stat, replace if necessary
ice thickness motor
defrosting thermostat
Seite 67