Wessamat CombiLine W80 Manuel De L'utilisateur page 68

User manual - English
Tub tilts fully, ice cubes
are discharged,
trough no longer returns
into original position
Tub tilts fully (contact
with limit switch
made) but immediately
returns to original posi-
tion
Ice cube maker
working despite produc-
tion switched on
Ice cubes stick to each
other during the ice-
making process
User-manual-CombiLine-W80-W120-W240-0299-2
1. Defrosting thermostat
but does not transfer voltage
to tilting motor
2. Tilting motor faulty
Mechanical or electrical
is fault at hot gas valve
not 1. Machine receives no
voltage from power supply
2. Storage container is full
(storage container ther-
mostat has switched off)
3. Storage
thermostat switches
before storage container
is full.
4. Ambient temperature
too low
5. Production switch of the
ice cube maker is faulty
6. Production switch in
wrong position ("Service"
or "Produktion aus/off").
1. Ice thickness motor
switches too late
2. Leak(s) in the cooling
system (ice maker has in-
sufficient refrigerant)
1. Readjust defrosting thermostat
(set to +17°C) or replace
2. Replace tilting motor 2
Abtauthermostat
Replace hot gas valve
1. Check socket
2. The ice cube maker will automati-
cally continue producing ice once a
sufficient quantity of ice has been
removed from the storage container.
container 3. Readjust storage container ther-
off mostat, or replace if necessary
4.Increase ambient temperature, or
relocated device if necessary
5. Replace production switch
6. Set production switch to position
"Produktion ein/on".
1. Readjust ice thickness motor(see
also capitel 6.3)
2. Locate leak(s), rectify and top up
refrigerant
Kippmotor
Seite 68