Wessamat CombiLine W80 Manuel De L'utilisateur page 54

User manual - English
2. Release the left locking screw at the ice thickness limit switch.
3. Change the position of the ice thickness limit switch:
Move upwards → thicker cubes
+
Move downwards → thinner cubes
-
4. Tighten the screw, insert the power plug and switch on
the machine (Position "Produktion ein/on") and monitor a
production cycle.
5. Once the required ice thickness is reached, switch off the
machine (Position "Produktion aus/off") and pull the power
plug. Replace the electrics box and housing covers and fas-
ten the screws. Re-start the machine.
IMPORTANT:
At the maximum setting, ensure that a minimum distance of approx. 1.5 to 2 mm remains be-
tween the individual finished ice cubes (see Fig. 6.3). Otherwise there is a risk of the machine
producing an ice plate, which would lead to malfunction.
User-manual-CombiLine-W80-W120-W240-0299-2
Minimum distance 1.5 – 2 mm
Fig. 6.3: Réglage de l'épaisseur des gla-
Fig. 6.3: Setting the ice cube
çons
thickness
Seite 54