Height And Thickness Of The Ice Cubes; Setting The Ice Cube Thickness - Wessamat CombiLine W80 Manuel De L'utilisateur

User manual - English

6.2 Height and thickness of the ice cubes

The height and thickness of the ice cubes produced de-
pends on the water level in the trough and on the ice
thickness motor setting. The water level is controlled
electronically via the water level sensor.
De The ice thickness motor checks the ice thickness
once every minute. Once the set ice thickness has been
reached, the ice thickness motors triggers the ice thick-
ness limit switch, thus initiating the defrosting phase.
The height and thickness of the ice cubes can be modi-
fied by adjusting the water level sensor and the ice
thickness limit switch (see chapter 6.3 and 6.4).
IMPORTANT:
Always adjust the ice thickness after the third ice production cycle. Only then does the machine
stabilize its ice production.

Setting the ice cube thickness

6.3
Switch off the machine at the production switch (Position "Produktion aus/off") and pull the
1.
power plug. Remove the machine cover and the cover of the technical equipment box (marked
with a flash symbol).
User-manual-CombiLine-W80-W120-W240-0299-2
Ice thickness limit switch
Water level
sensor
Ice thickness motor
Ice con-
trol mo-
torplate
Fig. 6.2: Side view of ice thickness motor
and water level sensor
Pivot
point
Lever
Seite 53