Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User manual – English
1. Basic Safety Instructions
1.1 Proper Use
The ice cube crusher is solely meant for crushing of small ice cubes. For crushing only the ice cubes produced
of ice cube makers should be used (not the deep frozen one`s).
Proper use shall also comprise observation of all directions of the operating instructions
1.2 Obligation and liability
1.2.1 Adherence to Directions of the Operating Instructions
A basic prerequisite for safe handling and troublefree operation of this machine is the
knowledge of the basic safety
instructions and safety regulations. These operating instructions, particularly the safety
instructions, shall be observed
by all persons operating the machine. In addition, the accident prevention rules and regulations
valid at the place of
installation shall be observed.
1.2.2 Hazards when Handling the Machine
The ice cube crusher was built in accordance with the state of technique and the approved
technical safety rules.
Nevertheless, use of this machine can cause threats for life and limb of the person using the
machine or third parties
respectively result in impairment of the machine or actual values. The machine shall only be
used
• for operation in accordance with instructions,
• if in technically safe and unobjectionable condition.
Troubles which may impair safety, shall be eliminated immediately!
1.2.3 Warranty and Liability
On principle, our "General terms and conditions" are applicable. The latter are available for the
user of the machine as
of conclusion of the contract at the latest. Warranty and liability claims for injuries to persons
and property damages
are excluded if they are not to be attributed to one or more of the following causes:
• operation of the machine not in accordance with instructions;
• improper installation, initial operation, operation and maintenance of the machine;
• operation of the machine with defective safety appliances or not properly installed or
unoperable safety
and protection devices;
• non-compliance with the directions of the operating instructions;
• arbitrary modifications of the machine;
• insufficient inspection of machine parts subject to wear and tear;
• improperly performed repairs;
• emergencies due to foreign matter and acts of God.
1.2.5 Structural Modifications of the Machine
No modifications, alterations or attachments to the machine shall be made without written
approval by
the manufacturer. In case of non-compliance, the manufacturer's warranty expires !
Change all parts of the machine which are not in an efficient shape. Use only original spare
parts! Other spare parts
do not guarantee to work correctly concerning security and wear and tear. Otherwise the
manufacturers warranty expires.
User-manual
-Crusher-v.03
.
07/2021
13
Publicité
Table des Matières
