Setting Of The Ice Cube Height - Wessamat HighLine W25 LE Mode D'emploi

User manual - English

6.4 Setting of the ice cube height

Switch off the machine at the production switch (Position "Produktion aus/off") and pull
1.
the power plug. Remove the machine cover and the cover of the technical equipment box
(marked with a flash symbol).
2. Release the fixing screw of the water level sensor.
3. Change the position of the water
level sensor
Move upwards → longer ice cubes
Move downwards → shorter ice cubes
4. Tighten the screw, insert the power
plug and switch on the machine (Position
"Produktion ein/on")
production cycle.
5. Switch off the machine (Position
"Produktion aus/off") and pull the power
plug once the required ice cube height is
reached. Replace the electrics box and
housing cover and tighten the screws.
Re-start the machine.
IMPORTANT:
At the maximum setting of the water level sensor, ensure that no water spills over the
edge of the trough during the production cycle (during trough movement).
User-manual-HighLine-v.02
and monitor a
Water level sensor
Abb. 6.4: Setting of the ice cube height
Tub
01/2021 51